|
|
3.7V LiPo |
x 1 | |
|
|
4-Pin JST 1.25mm PicoBlade Female to Female |
x 1 |
ESP32 CYD Battery Charger
This PCB adds a battery charging circuit to a CYD ESP32 board!
This board was made with the intention to avoid soldering. I’ve also added a pass through for a GPS module should you choose to add it.
Battery Info: JST PH 1.25mm 2-Pin Connector at 3.7V LiPo VERIFY POLARITY BEFORE CONNECTING
Cable needed: 4-Pin JST 1.25mm PicoBlade Female to Female (I use 10cm length but get the length you need)
Dimensions: 36x30mm
ESP32 CYD Battery Charger
Project images are for reference only. Actual production is based on the manufacturing files on the project page.
Please review the designer's notes (e.g., PCB thickness) and select the appropriate options.
PCBWay is not responsible
for issues caused by unsuitable parameter selections.
For more important ordering information, please refer to
Read More
Raspberry Pi 5 7 Inch Touch Screen IPS 1024x600 HD LCD HDMI-compatible Display for RPI 4B 3B+ OPI 5 AIDA64 PC Secondary Screen（Without Speaker）
BUY NOW
- Comments(1)
- Likes(7)
More by Hedge YT
-
-
-
-
AudioLink – USB & Bluetooth LE Audio / Auracast Receiver with Balanced Line Outputs (nRF5340)
328 0 1 -
-
-
-
Émetteur Récepteur Optique Expérimental (communication UART ATtiny + fibre optique)
384 0 1 -
SmallOLED - Live PC Stats, Animated Clocks & Audio Visualizer
1487 0 3
