Compact 433 MHz walkie-talkie based on MRF49XA transceiver
The project is about to create a small portable DIY walkie-talkie, based on the idea and schematics from the https://vrtp.ru/index.php?act=categories&CODE=article&article=3351 article.
It based on MRF49XA transceiver IC, PIC16F628 uC and support a direct half-duplex voice communication on ~433 MHz (up to 4 channels supported).
The overall distance of the original project is about 1.5 km, but my design uses a smaller voltage (3.7v with step-up converter to 5v), so the overall distance will be reduced twice a minimum. Waiting for the PCBs to give a try :)
The PCB was designed for the GAINTA G403 (G431) enclosure. You'll only need to drill a few holes (for the LEDs, switch, usb, volume control and atenna connector).
Compact 433 MHz walkie-talkie based on MRF49XA transceiver
*PCBWay community is a shared platform and we are not responsible for any design issues.
- Comments(2)
- Likes(1)
- Engineer May 11,2020
- 0 USER VOTES
- YOUR VOTE 0.00 0.00
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
More by Andrey Karpov
-
Open Source Very Large Stick - Freejoy & MMjoy2 breakout board
323 0 0 -
RF Control training board for students based on ESP32 C3
445 0 2 -
Aquarius+ Computer, Standard PCB
638 0 3 -
KINETIC COASTERS with a TWIST! Laser or 3D Print some DIY Magic
469 0 1 -
RPI - 8 IO PLC With ATTiny85 Watch Dog
411 0 0 -
Nintendo Famicom HVC-001 Controller Shells
508 0 1 -
COMMODORE 128 DIAGNOSTIC REV.785260 KEYBOARD DONGLE
485 0 4 -
COMMODORE 128 15KHz DISPLAY ADAPTER (C128 80 COLUMN ADAPTER)
604 1 4 -