Remote lockout pulley for rockshox sidluxe
The machining is very clean, and everything is well within the tolerances i specified. The slot in the center was a tiny bit too tight (the part was supposed to slide into a shaft with resistance, but on this one i had to give it a couple of taps with a rubber mallet), but that's not PCBway's fault, as they met my specifications perfectly, i was the one who specified the tolerances to be used after all. i just wanted a prototype done for cheap, and that's what i got. the quality is excellent and i have no complaints. there are no sharp edges that can cut you, even though the part doesn't have any aditional finishing. 5/5
Jan 17,2026
140 viewsReport item
- Comments(0)
- Likes(0)
Upload photo
You can only upload 5 files in total. Each file cannot exceed 2MB. Supports JPG, JPEG, GIF, PNG, BMP
0 / 10000
