I was surprised how well this came out, the material is incredibly tough. Held the dimensions very well. A simple sanding of the surfaces and the pieces fit together perfectl;y.
I had an excellent experience with this PCBWAY. I was genuinely amazed by the finished product. The quality far exceeded my expectations — the product is extremely well-made, very rigid, beautifully f...
Back left arm. Holes made small on purpose again so the self tapping screws could cut their own thread, same as the other three. Held up fine structurally, no cracking after screwing it in. Mounts acc...
This one needed the tightest tolerances since even a small shift throws off the camera calibration. Print came out flat and straight, no warping. Was worried the fit would be too loose and mess with c...
Custom spacers to run modern Volvo mirrors on a custom truck project. Surprised with the quality - I purchased SLM printed parts for a different project from PCBWay a few years back and these are noti...
I make props with my FDM printer, and I use resin casting for some of my parts. For these parts to be optically clear or have specular highlights (for lights, etc.), I need an extremely smooth mold bo...
I needed a modified version of a plug with very small details (0.35mm) and high dimensional accuracy. The parts came out perfect and worked great!
I ordered a thin mount to hide a GPS tracker on my bicycle. Before printing, the support team reached out to warn me that some areas in my design were too thin and recommended modifying the data to av...
I was surprised how well this came out, the material is incredibly tough. Held the dimensions very well. A simple sanding of the surfaces and the pieces fit together perfectl;y.
I had an excellent experience with this PCBWAY. I was genuinely amazed by the finished product. The quality far exceeded my expectations — the product is extremely well-made, very rigid, beautifully f...
Front left arm, same deal as the others, motor at the end so it takes similar torque and vibration. Stiff enough for the sensors, still light. Holes accurate to the mm, made small on purpose so the se...
Central chassis for my deadcat drone frame with an onboard camera setup. Needed to be rigid so the camera mounts don't flex mid flight. Nylon PA12, accurate to the millimeter, honestly better than I e...
Custom spacers to run modern Volvo mirrors on a custom truck project. Surprised with the quality - I purchased SLM printed parts for a different project from PCBWay a few years back and these are noti...
For this project, I wanted replacement Joy-Con wrist straps for the Nintendo Switch family of systems. These straps slide onto the sides of the Joy-Con controllers, and the finished parts matched the ...
I needed a modified version of a plug with very small details (0.35mm) and high dimensional accuracy. The parts came out perfect and worked great!
I designed this simple exhaust for the Sassi .15 engine or any engine with a 28mm bore spacing. The print quality was impeccable. The service was very good and attentive.
1 2 3 4 5 6 7 8 9 10 11 ...