Recommended
Shared Projects Questions Sponsorships Feedback Blog Like
this is a motherboard for a RF receiver working on short wave bands. It will be interfaced to three different boards through a 2x8 connectors (DDS board, RF/IF board and BaseBand board) in order to r...
I mounted manually components on the pcb. The two layers board works correctly. Beeing an experimental board, I needed to change some components many times but the traces of the printed circuit didn't...
the package has been arrived ijust in time. Both the pcb and stencil are ok and I have to mount all the SMD components into the oven.
components have been mounted on the pcb board and the project works very well. Pads of the board are easily weldable.
PCB is ok, I tested it and mounted the circuits on the board. Every test is compliance with the specification. Good result!
the non-framework stencil can be easily used over the pcb fixing it with a scotch tape.Laser holes are very precise.
this board is rather complex having 4 layers. Internal layers works well and the metalized holes are all correct. The board has been mounted without any problem. The circuit works accordng to our spec...