Recommended
Shared Projects Questions Sponsorships Feedback Blog Like
This was an adjustment to another design so nothing too crazy other than adding the graphic. Next time, I'll try to get cute and position the colorful resistor "as the body" of my butterfly graphic.
I designed this board to overlay 2 7-Segment Displays and chain the data and distribute power. I determined passing the power through; although an option, was not effective. I just designed another ...
I tried a stencil to apply solder paste to my small LED mounting board. I designed and 3D printed an alignment tool rather than loosely taped like seen on internet searches. The cutouts were located...
This was a second version, making some simplifications and fine tuning. The point is mounting buttons for a project with debounce circuits for each button to interface with an Arduino.
I tried a very thin board and a graphic. Both were a grand success.