Recommended
Shared Projects Questions Sponsorships Feedback Blog Like
The enclosure end plate for a DC power supply, including debossed labeling for input and output power sockets. Excellent quality and timely production and delivery.
This is version 2, with larger solder pads and a rearranged layout to eliminate interference with plugs from the enclosure. Excellent PCB quality and timely production and delivery.
A 3D printed metal (Aluminum) bracket for mounting a GNSS antenna on a pole. Excellent quality (didn't need to re-cut the thread, was fine as printed). First 3D printed metal part, vary happy with t...
A simple linear DC to DC regulated power supply. Very happy with the quality of the PCB
Capacitance multiplier used as a low pass DC filter. My first attempt at PCB design, with a minor routing error by me. Quality of PCB is excellent and exceeds my expectations. Will modify design an...
The enclosure end plate for a GPS receiver, including debossed labeling for all the sockets. Excellent quality and timely production and delivery.
This is version 2, with larger solder pads. Excellent PCB quality and timely production and delivery.
Prototype radial atomizer 3d printed in resin. After a slight redesign following very helpful feedback from PCBWay support team around some features that were too thin, very happy with the final prot...
Redesign of circuit for capacitance filter for DC power supply, to remove some errors on original design. Very happy with the quality of the final PCB
Electronics enclosure end plate, with multiple holes (not all circular). Test print in resin to check hole positions (some of which will need moving, which was the purpose of the test print). Excell...