Recommended
Shared Projects Questions Sponsorships Feedback Blog Like
This was a difficult board, as it's got a folded 900MHz antenna on it. The power amp reports that the VSWR is within range, so the board tolerances were spot on. Very pleased with this, and have jus...
Nice little SMT board with a bunch of power controllers and servo outputs. It's quite a cramped board, with double sides SMT, and a load of I/O connectors. But it came back on time, looking good, an...
This was a replacement controller board for a batch of LCD clocks. It required accurate placement of a set of gold plated finger contacts. There was some discussion about the requirements, but they ...
This is a touch panel remote control. So is mainly SMT, with touch areas. This needed tight size, and capacitance tolerance, but this first prototype worked first time. If you run a few projects in...
Another Simple through hold board, with 32 Servo control outputs. Good silk screen down to a small size, and solder resist perfectly aligned (which makes the 96 I/O pins trouble free to hand solder)....
This was a basic through hole board. Came back on time, looks good quality, the silk screen, and solder resist are even. The only problem was me getting two of the power pins swapped, so they have ne...