Recommended
Shared Projects Questions Sponsorships Feedback Blog Like
I had never ordered a PCB before so I wanted to check how they are going to be made. I also wanted to see if the pins of my footprints fit perfectly.
In my project this gear meshes with gearA but there seems to be no problems with this gear.
The gears were printed perfectly and the teethes fit well with each other.
Same goes for this gear
The 9mm bearings fit in perfectly with the 9.1mm hole in the design, and the screws also fit in perfectly.
The model looks alike the real mason motor and this is very good for mind storming.
This is the most fastest spinning gear in my project and the material was hard enough to deal with the high speed.
The gear was colored perfectly and there were the right amount of gears, but I had to make the 2 type of pieces easy to distinguish with each other.
I didn't think that the screws would go perfect with the resin pitch thread, and I am satisfied.