Recommended
Shared Projects Questions Sponsorships Feedback Blog Like
The part was extensively protected during shipping. The four machine screw holes align well with the lower assembly. The six holes hold Maxi Column well. There are some minor scratches on the side.
All features are within 0.4mm of spec. Arrived slightly wrapped. Due to a design error, the well in the center is too shallow for the 100mm Petri dish to sit in.
The 3D print turned out pretty well! Both the internal and external threads fit perfectly. The vacuum seal the adapter and the bottle created is sufficient to run a 0.22 micron bacterial filter. The t...
All features are within 0.4mm of spec. Arrived slightly wrapped. Fits well with the 60mm Petri dish.
The outer diameter is 0.4mm too wide. The inner diameter is 0.3mm too narrow. This results too tight a fit on the microscope objective lens. In the next revision I have to take those discrepancy into ...
This print is a replacement hand wheel for a MJ Research PCR thermocycler. The ID thunk slightly and require a Dremel to file off about 0.5mm.
The tenon is about 0.3mm too narrow, resulting a poor fit over the holding ring. The bottom of the tenon fall off the mortise on the holding ring for about 1.6mm. The cut out on the other end for the ...
The part was extensively protected during shipping. The four machine screw holes align well with the upper assembly. The six holes hold 50mL Falcon tubes well.
All features are within 0.4mm of spec. Arrived slightly wrapped. Due to a design error, the well in the center is too shallow for the 35mm Petri dish to sit in.