Share  

pickit 2 clone project

this is a programmer for pic ic`s / pickit2 clone


Jun 19,2017
5,562 viewsReport item
  • Comments(0)
  • Likes(2)
You can only upload 1 files in total. Each file cannot exceed 2MB. Supports JPG, JPEG, GIF, PNG, BMP
    View More

    You might like

    All the PCBs were perfect without faults (with some design errors on my part... ooops, thankfully they're prototypes!) The PCBWay team communicated with me very effectively on the design including whe...
    Great work. Thanks
    Nice made, clean edges and folded accurately.
    Very good, high quality pcb. Thank you.
    Overall the prints for this project came out great! There was a little bit of warping on the longer 2mm extrusion posts, but I think that might be more the limitations of the resin printing itself. No...
    a split keyboard for rhythm games (right hand). pcb quality is perfect. in first version I chosen wrong pin for serial communication, so it requires soldering 1 additional wire to work in split mode...
    My 3-Output power supply does not have the standard 0.75" spacing for the binding posts, so this board slides over the binding posts and provides an offset hole for a banana jack that is properly spac...
    I needed to make a Dev board for testing the ESP32-WROOM-32D Micro controller. So, I made a simple break-out board for the ESP32 & am very happy with the result. Thank you very much PCBWay.
    SHOW ME MORE
    x
    mm
    Earn a $5 Welcome Bonus
    Mihai?Dan?Virgil View Profile
    4posts 0followers 0following