Share  

Updated bed plate for my VMinion to add silicone dampers

Really great finish - love the result and the poweder coated surface is awesome, though its important to take into account the powder coating have to be calucalted in tolerances


Jan 12,2023
306 viewsReport item
  • Comments(0)
  • Likes(0)
You can only upload 1 files in total. Each file cannot exceed 2MB. Supports JPG, JPEG, GIF, PNG, BMP
    View More

    You might like

    All the PCBs were perfect without faults (with some design errors on my part... ooops, thankfully they're prototypes!) The PCBWay team communicated with me very effectively on the design including whe...
    Great work. Thanks
    Nice made, clean edges and folded accurately.
    Very good, high quality pcb. Thank you.
    Overall the prints for this project came out great! There was a little bit of warping on the longer 2mm extrusion posts, but I think that might be more the limitations of the resin printing itself. No...
    a split keyboard for rhythm games (right hand). pcb quality is perfect. in first version I chosen wrong pin for serial communication, so it requires soldering 1 additional wire to work in split mode...
    My 3-Output power supply does not have the standard 0.75" spacing for the binding posts, so this board slides over the binding posts and provides an offset hole for a banana jack that is properly spac...
    I needed to make a Dev board for testing the ESP32-WROOM-32D Micro controller. So, I made a simple break-out board for the ESP32 & am very happy with the result. Thank you very much PCBWay.
    SHOW ME MORE
    x
    mm
    Earn a $5 Welcome Bonus
    Engineer View Profile
    2posts 0followers 0following