Smash Boom Bang

Very detailed cutout. The stainless steel is debured and brushed to get a good relief from the paste. I use it for pads with a width of 0.3mm and it works very well. I have to use LOCTITE RP15 paste with 24µm particles and a credid card type squeegee to have a good result. After applying I can place components for about 10 minutes until the paste gets to dry. I reflow solder the parts with a hot air gun giving the whole board heat with a circular motion.

Dec 05,2018
293 viewsReport item
  • Comments(0)
  • Likes(0)
You can only upload 1 files in total. Each file cannot exceed 2MB. Supports JPG, JPEG, GIF, PNG, BMP
0 / 10000