LED Shade Projector Base Housing

Overall the prints for this project came out great! There was a little bit of warping on the longer 2mm extrusion posts, but I think that might be more the limitations of the resin printing itself. No matter as it did not prevent the device from being assembled. I realized from the prints though, that I put a post on the bottom when it should been from the top piece by the button otherwise it won't actually let the PCB go in hahaha, this is why you 3D print prototypes. I just snipped it off and it was all fine.

Jan 27,2023
705 viewsReport item
  • Comments(0)
  • Likes(0)
You can only upload 1 files in total. Each file cannot exceed 2MB. Supports JPG, JPEG, GIF, PNG, BMP
    View More
    Earn a $5 Welcome Bonus