Good job
A stencil to make SMD manufacturing of the CAN-BUS Relay Module a bit faster and easier. The stencil was well made and all footprints are correct. Thank you
A stencil to make SMD manufacturing of the LoRa-CAN PCB a bit faster and easier. The stencil was well made and all footprints are correct. Thank you
Very fast delivery and very support
A stencil to make assembly a bit faster :) PCBWay did a great job on this as well, it is accurate and all component footprints are correct... Thank you
Good products.
A simple base board for LoRa experiments. To be expanded on as a general communications device for use on the farm to do things like intrusion detection, water and electricity monitoring, as well as g...
My version of the USB-ASP Programmer for ATMEGA devices. I made some minor modifications to the original circuit, namely adding level conversion to enable programming of 3.3v devices as well. I also a...
Having a lot of SMD resistors in little plastic bags gets annoying after a while. I decided to use some beans and buy containers. It will surely help make my life a bit more organised, as well as add ...
This device is meant to be connected via CAN-BUS to the LoRa-Can module, for use as a remote control and input node. I tried to keep the board as small and compact as possible, and as the intended use...
This is a follow-up on my LoRa device design journey. In this design, I have added an integrated CAN-Bus module to the Lora Base Module. CAN-Bus will add quite a lot of functional advantages to the mo...
This is an EXTREMELY simple, but very essential prototype. I have an application where I need to monitor a solar battery system, ( voltages only for now ) as well as be able to detect intrusion into t...
This project is a particularly difficult one, as it involves a few handmade footprints, as well as having to fit into a very specific plastic enclosure. Measuring the enclosure, with its very generic,...
Stencil to ease in production of the LoRa base module. The stencil was manufactured well, all component footprints are correct.
A stencil to make assembly of the USB-ASP Programmer easier. Component footprints are correct, stencil was manufactured well.
good job
1 ... 30 31 32 33 34 35 36 37 38 39 40 ...