The tenon is about 0.3mm too narrow, resulting a poor fit over the holding ring. The bottom of the tenon fall off the mortise on the holding ring for about 1.6mm. The cut out on the other end for the ...
impresión muestra para prototipo
Could not be happier with the final product in aluminium. surface finish is great and dimensions are all within acceptable tollerance.
This part of my project and it was my first time order from this website, quality and aquracy of 3d printing was closed to 100%. I'm very satisfied with it.
The ordering process was pretty smooth with only a few delays in email responses, but overall great service. It's good to be able to order something so quickly and in low quantities. All parts are hig...
The ordering process was pretty smooth with only a few delays in email responses, but overall great service. It's good to be able to order something so quickly and in low quantities. All parts are hig...
This part was a prototype of a small link to hold bushings that was designed for lightweight aluminum. Machining the part would be inexpensive, but I used the AlSi10Mg printing service from PCBWay to...
Air swirler, elegant air choke, perfectly mapped dimensions. Excellent surface finish of the swirler blades. Fits the diffuser with a 90mm screw-mounted hole.
The 3D print turned out pretty well! Both the internal and external threads fit perfectly. The vacuum seal the adapter and the bottle created is sufficient to run a 0.22 micron bacterial filter. The t...
Case for my FM radio
very satisfied, thanks for the work! I will repeat other orders
The ordering process was pretty smooth with only a few delays in email responses, but overall great service. It's good to be able to order something so quickly and in low quantities. All parts are hig...
The ordering process was pretty smooth with only a few delays in email responses, but overall great service. It's good to be able to order something so quickly and in low quantities. All parts are hig...
This part was a prototype bracket with a topology optimized design for optimum stiffness to weight given critical stresses and mass target, printed by PCBWay in 316L Stainless Steel. The parts came o...
I am an engineer who is creating a european startup to make very complex jigs and tooling for the automotive sector using our in house developed generative CAD design software. For the past weeks, I ...
This is a prototype of a solid state anemometer. Designed with FreeCAD and fabricated with PCBWay. It is perfect! In particular the channels are perfectly opened (they are 1mm of diameter only!) .
1 ... 12 13 14 15 16 17 18 19 20 21 22 ...