The texture and look of this is wonderful, thanks!
It came just in time and it was exactly what I wanted
This is a scale model of a tank radiator. There are a few belts and pipes that are smaller than recommended sizing and I accepted deformation responsibility. Even so, they printed perfectly and I am q...
This is a scale model hardcase for use in a diorama. The hinges and latches look great and the feel is very smooth and solid.
This is a scale model of a man thinking. The details may not be as crisp as a Games Workshop miniature, but I still consider the print very successful.
This is a diorama part with many knobs and dials on the side of electrical equipment. The details have very minor interference from print lines because of how small they are, and overall it looks grea...
This is a model crate for use in a diorama.
This is a very small scale model of a propane cylinder and it came out great in resin.
Came out great! There was slight warping on the lid piece, but that's to be expected. Very minor and not noticeable in the final product.
This is a custom model of a generic panel with slits. This falls outside of the recommended minimum of 1mm thickness, but it printed perfectly (probably because it is a simple planar design) and is ex...
This is a custom model of a vent with 0.8mm spacing. This falls outside of the recommended minimum of 1mm thickness, but it printed perfectly (probably because it is a simple planar design) and is exa...
This is a scale model of a woman. The details may not be as crisp as a Games Workshop miniature, but I still consider the print very successful. She is holding out her hand, which seems to have warped...
This is a scale model transpallet with very thin parts that was expected to fail. I ordered this to see what limitations there were with resin prints. The handle is slightly bent but overall it's surp...
This is a communication rack with radios, dials, buttons, etc for use in a scale model diorama. One leg of one rack is warped, as was warned by the engineers before I accepted liability for deformatio...
This is a small model crane/engine hoist for use in dioramas. I was warned that there are parts too thin to print and may cause deformations. The thinnest parts have some warping but overall the print...
Resin print of knobs of an old radio era unobtainable. Impeccable service, short times, really competitive costs and very helpful.