Sipeed Maixduino + 2.4'' TFT LCD
- Arduino UNO R3 Pins compatible
- Maix M1 module
- ESP32-WROOM-32 WiFi module (2.4G WiFi + Bluetooth)
- 4 indicators (esp32 and k210 serial port send and receive indicators)
- 2 buttons (reset and start selection (customizable function after power on) button)
- Type-C interface
- Micro SD card slot
- 1 CH552 USB to TTL chip
- 2 FPC carriers (camera and screen)
- 1 Mic
- 1 mono audio amplifier (NS4150)
- 1 LCD touch screen (optional)
- 1 1.25mm audio output female
1. Attention
Although the shape and Pin
are compatible with Arduino UNO R3
, the voltage level is not compatible, which requires great attention, otherwise the board may be damaged!
Maixduino
supports 3.3V
and 1.8V
levels, and the pins are divided into several BANK
, each BANK
can be set to a voltage of 1.8V
or 3.3V
by software, However, these pins are not `5V' tolerated.
Therefore, when using the peripheral device of Arduino
, be careful not to short the 5V
to the pin or RST
(1.8V
) pin, otherwise the board may be damaged!
2. Assembly
Pay attention to the installation direction of the camera and screen, otherwise it may not work or damage the device.
The camera is facing the back:
Screen facing the front
3. Docs & Downloads
- Pin map PNG picture Download
- Specifications(include Pin map form):Specifications
- Hardware Information: dl.sipeed.com
- SDK: Applies to all SDKs of the k210 series
4.Specification
5.Part List
1 x Maixduino dev. board
1 x 2.4'' TFT LCD(240x320 )
- Comments(0)
You might like
-
-
-
Universal e-Paper Raw Panel Driver Board(ESP32 supports WiFi and Bluetooth)$12.99 or 1560 BeansRedeem Now
-
-
-
-
-
-25%
-
-12%
-
-
-
-
-