Nano Base Board (A) for Raspberry Pi Compute Module 4
Nano Base Board (A) For CM4
Suitable For Evaluating The Raspberry Pi CM4 Or Being Integrated Into End Products
Base Board for Compute Module 4 Lite/eMMC
Same Size As The CM4
Standard CM4 Socket, With Multiple Peripheral Interfaces, Suitable For Narrow Application Environment
Specifications
- CM4 SOCKET: suitable for all variants of Compute Module 4
- CONNECTOR: Raspberry Pi 40PIN GPIO interface × 1
- USB: USB 2.0 Type A interface × 1
- CAMERA: MIPI CSI-2 port × 1 (15pin 1.0mm FPC connector)
- STORAGE: Micro SD card socket for Compute Module 4 Lite (without eMMC) variants
- POWER INPUT: 5V
- DIMENSIONS: 55 × 40mm
What's On Board
1.CM4 socket
suitable for all variants of Compute Module 4
2.Power supply / Programming
5V power supply, or used for eMMC burning
3.Micro SD card slot
for connecting a Micro SD card with pre-burnt image (Lite variant ONLY)
4.CSI interface
1 × MIPI CSI camera interface
5.USB2.0 interface
for connecting sorts of USB devices
6.40PIN GPIO interface
suitable for connecting to various HAT modules
7.PWR indicator
CM4 power status
8.ACT indicator
CM4 working status
9.AMS1117-3.3
10.BOOT switch
ON: Switch USB to Type C interface, will enter download mode when powered on (configured as a large-capacity disk through RPI boot)
OFF: Switch USB to Type A interface, will not enter download mode when powered on (booted from eMMC or Micro SD card)
Outline Dimensions
- Comments(0)
You might like
-
-
-
-
-
-
-
-
-
-
-
-
-
-
I2C Interface Of Raspberry Pi Serial Port Expansion Board (expanding 2 UART and 8 GPIO)$14.99 or 1800 BeansBUY NOW
-
-
-
-
-