Product Description
Four Way Holder V3 Development Board（Compatible with Raspberry Pi/STM32)
What makes it special?
- Battery protection (overcharge or over-discharge)
- Miniature USB port input
- Type a USB output.
- 0.5 A current charging.
- 1 switch controls USB output /5 ~ 8 V input voltage.
- Output of 3 V and 1 A and output of 5 V voltage 2 A.
- LED indication (green, red for charging)
- 3 V output port.
- The 5 V output port should be careful with "+"and "-", and the direction you should follow is "+" and "-" on the PCB.
Note: If you put it in the wrong direction, the charging chip will be destroyed. This product does not include battery 18650.
- Comments(0)
Upload photo
You can only upload 5 files in total. Each file cannot exceed 2MB. Supports JPG, JPEG, GIF, PNG, BMP
0 / 10000
You might like
-
-24%
PCBWay Single-Channel Relay Module with Delayed Power-off, Triggered Delay, and Cyclical Timing Circuit Switch$1.50 or 150 BeansRedeem Now -
-
Four Way Holder V3 Development Board（Compatible with Raspberry Pi/STM32)$9.00 or 900 BeansRedeem Now
-
-
-50%
1 Channel Relay Module 5V with optocoupler Support High and Low Level Trigger$1.00 or 100 BeansRedeem Now -
Relay Module Interface Boards for Arduino Low Level Trigger 5V 2 Channels$2.00 or 200 BeansRedeem Now -
-
LM2596S DC-DC 3A Buck Adjustable Step-down Power Supply Converter Module$1.00 or 100 BeansRedeem Now -
-
-
-
Step-Down & Step-Up Converter DC-DC 1.8V-5V 3V 3.7V to 3.3V Power Module$1.00 or 100 BeansRedeem Now
Power
Four Way Holder V3 Development Board（Compatible with Raspberry Pi/STM32)
Product ID: LP411
(Coupon is not available)
In Stock
In Stock
2648
0
US $9.00
Quantity:
Exchange
Method:
Cash
Bean
