Product Description
18650 Battery Holder V3 Development Board(Compatible with Raspberry Pi/STM32)
What makes it special?
- Battery protection (overcharge or over-discharge)
- Miniature USB port input
- Type a USB output.
- 0.5 A current charging.
- 1 switch controls USB output /5 ~ 8 V input voltage.
- Output of 3 V and 1 A and output of 5 V voltage 2 A.
- LED indication (green, red for charging)
- 3 V output port.
- The 5 V output port should be careful with "+"and "-", and the direction you should follow is "+" and "-" on the PCB.
Note: If you put it in the wrong direction, the charging chip will be destroyed. This product does not include battery 18650.
- Comments(0)
You can only upload 1 files in total. Each file cannot exceed 2MB. Supports JPG, JPEG, GIF, PNG, BMP
0 / 10000
You might like
-
-
-15%PCBWay Single-Channel Relay Module with Delayed Power-off, Triggered Delay, and Cyclical Timing Circuit Switch$1.69 or 200 BeansRedeem Now
-
-
Four Way Holder V3 Development Board(Compatible with Raspberry Pi/STM32)$8.99 or 1080 BeansRedeem Now
-
-
1 Channel Relay Module 5V with optocoupler Support High and Low Level Trigger$2.00 or 200 BeansRedeem Now
-
-
-
USB isolator/USB to USB isolator digital signal audio power isolator ADuM3160$9.99 or 1200 BeansRedeem Now
-
-
-
Dual 18650 Battery Holder V3 Development Board(Compatible with Raspberry Pi/STM32)$4.99 or 600 BeansRedeem Now
-
18650 Battery Holder V3 Development Board(Compatible with Raspberry Pi/STM32)$3.99 or 480 BeansRedeem Now
-
LM5122 Adjustable Step-up And Regulated Power Supply Module (12V-48V)$12.00 or 1400 BeansRedeem Now
-
-
-
-
-