ARDUINO UNO REV3
Arduino Uno is a microcontroller board based on the ATmega328P (datasheet). It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 analog inputs, a 16 MHz quartz crystal, a USB connection, a power jack, an ICSP header and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or power it with a AC-to-DC adapter or battery to get started. You can tinker with your UNO without worring too much about doing something wrong, worst case scenario you can replace the chip for a few dollars and start over again.
MicrocontrollerATmega328POperating Voltage5VInput Voltage (recommended)7-12VInput Voltage (limit)6-20VDigital I/O Pins14 (of which 6 provide PWM output)PWM Digital I/O Pins6Analog Input Pins6DC Current per I/O Pin20 mADC Current for 3.3V Pin50 mAFlash Memory32 KB (ATmega328P) of which 0.5 KB used by bootloaderSRAM2 KB (ATmega328P)EEPROM1 KB (ATmega328P)Clock Speed16 MHzLED_BUILTIN13Length68.6 mmWidth53.4 mmWeight25 g
- Comments(0)
You might like
-
-
ESP32 WiFi Bluetooth Dual-mode Communication Development Board With Camera$19.99 or 2400 BeansBUY NOW -
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
ARDUINO UNO REV3
-10%In Stock
