Amplifier board for two LM3886 with parallel connection.

This board is for a power amplifier project that uses two LM3886 chips per channel, in a circuit with parallel connection. At 8 ohm load, the output power of the amplifier is of the order of 50 watts, for a 4 ohm 100 watts. The amplifier design uses four LM3886 chips. The LM3886 is connected by a non-inverting amplifier circuit. The development of the printed circuit board was carried out taking into account that the power ground (power supply) and the signal ground were separated. The signal ground is in the middle and is surrounded by power ground. When assembling the amplifier, high-quality Mundorf and Nichicon capacitors will be used.




May 14,2018
209 viewsReport item
  • Comments(2)
  • Likes(0)
You can only upload 1 files in total. Each file cannot exceed 2MB. Supports JPG, JPEG, GIF, PNG, BMP
  • Thank you PCBWay for the fast and high-quality manufacture of circuit boards. The boards were delivered in 23 days.

    Reply
  • Thank you

    Reply

You might like

x
mm
Earn a $5 Welcome Bonus