Clean and easy transaction using an existing Gerber and bom from an opensource project on GitHub. Communication was easy for this, my first PCB order ever, and production was super quick and straightf...
The print is very well done. No surface defects detected.
The print is very good, some grinding marks are visible but it doesn't matter to me as surface finish is not critical in my application. Their is little geometric defect that is not critical too.
The part is perfect.
This is a prototype to investigate a combined AC/DC Dynamic LOad
This is the Back Panel for a DIY Dynamic DC Load
This is the Controller board for a DIY Dynamic DC load
This is a very sensitive connection tracer to find shorts on PCB's. One PCB will act as the sender, and one as the receiver.
The part is perfect and within tolerences. The surface finish is better than expected.
Perfect print
The print is very good, some grinding marks are visible but it doesn't matter to me as surface finish is not critical in my application.
The part is perfect.
This is an updated version of a DIY GPSDO
This is a prototype for the Controller board for a DIY Dynamic DC load
This is the Front Panel for a DIY Dynamic Load
This is a mailbox transmitter and a receiver using the same PCB, that is using the LoRa protocall to signal if the is mail in the remote mailbox.