A learning project as its my first
This is a mechatronoics project completed at the university of Newcastle by 3rd and 4th students independently. components used are: Atmel ATMEGA32A micro-controller, GY-521 6 DOF MPU-6050 Module 3Ax...
Using a Fairchild SPM module and a Delfino Microcontroller we are designing a three phase inverter.
Controller board for a powerful LED strobe light. Used as a tail strobe on home built aircraft. This one has switchable modes and two circuit operation. www.flyleds.com
These boards used relays to turn on/off high current outputs
Replaces the Famicom power/rf board with a clean dc board and RCA outputs
I needed a way to control 4 motors with only 1 controller, this little board done the trick!
A PICAXE microprocessor is connected to the radio buttons and when required turns on the Bluetooth module to provide a connection to a phone or tablet and allow music to be played. The Bluetooth modu...
This board was made as an interface board which can be programmed to control almost anything. On the board, there are 16 buttons which 8 of which are encodes. Each button has 2 LED. The outputs can be...
Using a fairchild SPM and Delfino Microcontroller, we are designing and three phase inverter.
Wing mounted boards that have red/green position lights and bright LED strobes
Controller board for a powerful LED strobe light. Used as a tail strobe on home built aircraft. www.flyleds.com
-
Designed in Altium, 1.6mm thick, 2 layer, HASL, 36 x 35mm.
PCB is for the analog front end of the scope, which interfaces with a Tiva C development board, which provides the ethernet PC connection. Channel A also affords band pass sampling from 650-750kHz. Fi...
I am very happy with the quality of the PCB, the holes aligned perfectly with the bolts of the chassis.