Just designed and manufactered my BlueNRG-based PCB on PCBway, see attached picture for a 2-layer PCB with a PCB antenna works at 2.4GHz. PCB specs: Length : 55 mm Width : 30 mm Quantity : 10 Lay...
For the designed 200W wind tribune, input: 6-24V, Output: 12V / 17A with constant voltage generator design is targeted. Full-Bridge Converter structure is preferred for the topology and model of the s...
It continues from where it left the counter with a power outage. 99 hourse 99 minutes
Unmanned ground vehicle capable of 1 kgs of payload and 1km remote control range
multi design cards.
2 layer PCB Blue Mask
The projects goal is to design an interferometer which could detect angular position of an unltrasonic source in water. Although all tests are not completed yet, it seems the design will work.
this project is our educational project in school.
a LED luminaire consisting of
Timer and signals
nRF24L01 2.4Ghz PA+LNA, Arduino, RC Transmitter, 0,96" oled
USB2RSx project is 3kV, fully isolated RS232 and RS485 converter with same unit. It can be worked with 2.5MBits speed. It can deliver its power from USB. You can use TTL RX/TX/DIR output for TTL level...
Magnetic and inductive proximity sensors controller project.
5 MHz IF to 433 MHz RF at Transmitter 433 MHz RF to 5 MHz IF at Receiver
N/A
Excellent work