Smallest board that I designed so far. Consisting of accelerometer sensor, some passive component, and an IDC connector.
It's a 2 layer board with 1 oz copper finishing. The board will contain two lithium ion battery, battery charger IC, and a sepic regulator, etc. The board has a lot of analog stuff on it. This board a...
This design was actually my first PCB which I pick a 2 oz copper finishing. Because in the circuit some trace might not be able to handle the current requirement, if it was only implemented with 1 oz ...
It's a general purpose microcontroller board with some connectivity like ethernet, USB, wifi (esp32). Also have eeprom on board and socket for micro sd card. Due to this many peripheral implemented on...
It's a small board with simple circuit and minimal component. No problem, no issue faced, thanks.
It's a standard single layer board with some passive components and connectors (hence the name interface board). I'm not sure the different between surface finish with silver or gold (enig), but so fa...
This is the third revision of my general purpose microcontroller board for use in the lab product in the company where I work. Actually no significant change from the second revision, only some parts ...
It's a small board for interfacing purpose. It convert uart signal from mcu to rs-485 using a transceiver from maxim integrated. There's a pin to control the direction (switch) between sending or rece...
The assembly of my board was done perfectly by pcbway. Unfortunately the board not 100% working, there's an issue that I faced regarding the sensing of the battery by the charger IC. I should've follo...
This board also my first design that has a lot of components assembled not only in the top, but also a lot in the bottom side. When I got the board, I tested it, and actually everything were working. ...
Because there're a lot of parts in the BOM, and it was during this time I started to feel the impact of the pandemi, which is the shortage of component in supplier (Digikey and Mouser). Some of my par...
It's a small board with simple circuit and minimal component. No problem, no issue faced, thanks. Good job!
In the assembly of this board, there're several axial through hole resistors, radial aluminium electrolytic capacitor, and also one axial through hole diode. Some through hole connector for example ID...
The assembly was perfect, I've got no complain. Only very weird that among 5 boards, there's actually 1 board that has microcontroller can't be programmed, it's not responding when I do it like usual ...
The assembly for this small board was perfect, I've got no complain. Actually this is my first time to have a 8p8c modular connector on my board design, the connector for RJ-45 cable. And I just know ...
This is just standard interface board for RS-485 communication via 8p8c modular connector. I was actually making this prototype to test if it's going to work when the channel being parallel, also I wa...
1 ... 27 28 29 30 31 32 33 34 35 36 37 ...