After sanding and filling worked quite well for a scale model glued well with CA glue, good Mr Hobby finishing Primer adhesion. Very fine detail, structually great plastic material. Very clean finish....
This is one of a few parts for a weighing system to get to know the amount of coffee in the cup during a brew prozess on an espresso machine. All of this is carried out in the name and form of the Ga...
Using the UTR-8100 Material for our IR-sensor case was a very good decision, the Sensor Window is waterclear and we could perfectly test the design before ordering a expensive mold
great quality and service
Klare transparente Preise. Gute Qualität. Schnelle Lieferung. Keine 6 Arbeitstage von der ersten anfrage bis zur Zustellung der fertigen Teile.
Everything fine!
Good printing, thanks
nice work
This is a cover/shroud thats desined to clip over a crimped connector. Its located over a coffee machine boiler which is reaching temperatures of up to 150 degrees Celsius. The wall thickness of a...
This is a clip thats acting as a viewport and as a holder for a 6mm 230V lamp, to be used in place of the originals on an espresso machine. All of this is carried out in the name and form of the Gagg...
This was my first 3D Design for my electronic board. Thanks to PCBway I found the right material and I can redesign some too small details before the manufacturing starts. The case looks good and the ...
great quality and service
This is one of a few parts for a weighing system to get to know the amount of coffee in the cup during a brew prozess on an espresso machine. All of this is carried out in the name and form of the Ga...
everything fine!
nice work
Excellent quality for small prototypes. Mind that unlike casting where parts tend to shrink, additive printing actually makes part swell a bit :)
1 2 3