I CAN SOLDER Kit 2019


### DESCRIPTION

So I could make a 3D design for the case and this is a final product that could end up on Kickstarter. It is a very cheap project, around 15$ for all the parts . On this tutorial you willhave a full part list, the schematic and layout of the board in case you want to amke it. I also share the 3D STL files for the case so you could print it.


Below we have the schematic for this board. To supply it we use a type mini B USB connector. That is connected to the power MOSFET but also to some pads for the buck converter so we could get 5V for the other microchips. Now the 16Mhz crystal is smaller so we have more space on the PCB for future improvements. We haev 2 push buttons to set the temperature and other settings, a vibration sensor for the sleep mode and the ATmega328p.AU microcontroller. 


### TECHNICAL DETAILS / COMPONENTS

Part list


### LEARN / TOPIC / BUILD INSTRUCTIONS

3D case


STL files for the 3D case. Dwonlaod each file and print them. They are already oriented so you don't have to do enything. The case is made out of 4 parts. The top aprt, the bottom part and two small push buttons. I've used PLA material for each. Alos, a 0.4mm nozzle of my printer, 0.2mm layer height, 2 perimeters and 100% infill at a temperature of 200oC.


Autor project: ELECTRONOOBS Barcelona, Spain \ Andrei Gabriel Anghel

Dec 10,2018
539 viewsReport item
  • Comments(0)
  • Likes(4)
You can only upload 1 files in total. Each file cannot exceed 2MB. Supports JPG, JPEG, GIF, PNG, BMP
    View More
    VOTING 2 votes
    • y****xru from BELGIUM
      • 10
        design
      • 10
        usability
      • 10
        creativity
      • 10
        content
      10.00
    • z****fan from INDONESIA
      • 10
        design
      • 10
        usability
      • 10
        creativity
      • 10
        content
      10.00
    View More