|
PZ254V-11-04PXFCN
|
x 2 | |
|
PZ254V-11-3PXFCN
|
x 4 | |
|
PZ254V-11-12PXFCN
|
x 1 |
|
ky-004 button moduleAZ-Delivery
|
|
|
ky-016 rgb led moduleAZ-Delivery
|
|
|
ky-019 realy moduleAZ-Delivery
|
Dual octoprint setup pcb for button, relay and rgb led
This pcb is used to connect button, relay and rgb led modules to raspberry running 2 instances of octoprint.
Each octoprint instance has its own dedicate button, relay and rgb led module.
I use the following octoprint plugins and arduino modules:
The rgb led is used to indicate the state of the printer (e.g. green printing, red error/print cancelled).
The button is used for emergency stop.
The relay is used to power on/off the printer.
Thanks to the plugins it can be configured differently (e.g. rgb more colors for more states, button for other macros).
I've connected the raspberry pi, the pcb and the modules like the image bellow (it can be configured differently according to the GPIO pins available).
I can be used with only one instance of octoprint or other modules according to the pins available.
Dual octoprint setup pcb for button, relay and rgb led
*PCBWay community is a shared platform and we are not responsible for any design issues.
- Comments(0)
- Likes(0)
- 0 USER VOTES
- YOUR VOTE 0.00 0.00
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
More by Gianluca Fabris
-
Open Source Very Large Stick - Freejoy & MMjoy2 breakout board
308 0 0 -
RF Control training board for students based on ESP32 C3
433 0 2 -
Aquarius+ Computer, Standard PCB
622 0 3 -
KINETIC COASTERS with a TWIST! Laser or 3D Print some DIY Magic
459 0 1 -
RPI - 8 IO PLC With ATTiny85 Watch Dog
403 0 0 -
Nintendo Famicom HVC-001 Controller Shells
498 0 1 -
COMMODORE 128 DIAGNOSTIC REV.785260 KEYBOARD DONGLE
481 0 4 -
COMMODORE 128 15KHz DISPLAY ADAPTER (C128 80 COLUMN ADAPTER)
585 1 4 -