Two silkscreen files in your gerber file

Reason of failed review:

Normally, there are only 1 top silkscreen layer and 1 bottom silkscreen layer in 1 gerber file. But in your file, there are 2 top silkscreen layers.

Suggestion:

1. If both top silkscreen files is needed, pls tell us. We will combine them;

2. If only 1 file is needed, psl advise which one we should follow;

undefined

BTW, next time, you can write “only 1 top silkscreen is needed, it is ***** layer” or “there are 2 silkscreen files are needed, there are ****+****” on the other special request to avoid the same question.

The parameters in gerber files are different from the order details online.
V-cut standard-Limited to Quick-turn PCB
Soldermask bridge
Some drills overlap the slots at GM or GKO
The outline of shape is too thick to ensure the dimension of PCB
The layout of PCB is unclear
Solder mask layer is opening entirely
Gerber files are not completed
Route Process in panel file
Several gerber files have in your order
Solder mask file is empty or None
Stackup information
The tab route is smaller than 1.6mm
V-scoring line/Slot in silkscreen layer
Some Issues concerning BGA(Ball Grid Array)
Design has no silkscreen layer but online is yes with silkscreen
Please clarify 1-layer or 2-layer
Requirement about castellated holes
The distance between the trace and board outline is less than 0.25mm
The holes is in the trace and it will cause open circuit

Comments (0)

This message here is only a suggestion supplement to the above content, and does not for trading operations such as orders. If you have any urgent questions or order issues, please contact your sales rep.

Upload a photo: You can only upload 1 files in total. Each file cannot exceed 2MB. Supports JPG, JPEG, GIF, PNG, BMP

0 / 10000

Two silkscreen files in your gerber file

Related articles